There is a pressure adjustment device at the front end of the compression section of the automatic molding machine, which is used to adjust the compression ratio. According to the characteristics of the material, the compression ratio can reach 30 to 40 times, so as to achieve the purpose of reducing the volume of EPS, so that it can be transported and stored in long distances. Transport capital. The cold-pressed EPS briquetting machine uses a screw to directly push and extrude EPS foam without heating. Hasswell introduced its smallest screw compactor at the 2007 K exhibition in Germany, the model is cp- 130. The capacity of this machine to handle EPS is 13.6~18.4kg/h, and the density of the final product will increase by 40 times. The latest compaction density control can even reach 320.5kg/m3. The hot-pressing briquetting machine is mainly used for pressing PU material, the difference between hot-pressing briquetting machine and cold-pressing briquetting machine is.

The model is cp-130, the capacity of this machine to handle EPS is 13.6~18.4kg/h, the density of the final product will increase by 40 times, the latest compaction density control can even reach 320.5kg/m3, hot-pressing briquetting machine, It is mainly used for pressing PU material. The difference between the hot-pressing briquetting machine and the cold-pressing briquetting machine is that a heater is added to the pressing section of the cold-pressing briquetting machine, so that the material passing through the heating section is semi-melted. The state is extruded from the discharge port. Heger exhibited this type of briquetting machine at the K exhibition in Germany in 2007.

In addition to safety, it is also necessary to look at the convenience of operation and use. After understanding these basic conditions, you can naturally choose to stop normally. Usually, after understanding these basic conditions, many people feel that they are affected by the entire market. The farewell level is very high, and it can be easily purchased.