Auto Digital Lost Foam Block Molding Machine china is a new type of building material production equipment, which has the advantages of high efficiency, energy saving and high degree of automation, and is widely used in various fields. However, when using Auto Digital Lost Foam Block Molding Machine china, there are also some things that need to be paid attention to to ensure its safe operation and excellent performance. The following is an introduction to the precautions for using Auto Digital Lost Foam Block Molding Machine china.

Preparation before use

Before using Auto Digital Lost Foam Block Molding Machine china, you need to do the following preparations:

1. Check whether the electrical circuit is normal and whether the power supply is stable.

2. Check whether the oil quantity of the lubrication system is sufficient and whether it is operating normally.

3. Clean up all parts of the molding machine, pay special attention to whether the worn and fallen parts need to be replaced or repaired.

4. No-load test machine, check whether the adjustment of the equipment is appropriate and whether the operation is stable.

Correct operation of Auto Digital Lost Foam Block Molding Machine china

1. Prevent excessive load on Auto Digital Lost Foam Block Molding Machine china.

2. Adjust according to the size requirements of the pressed blocks and the block strength requirements to ensure the forming quality of the blocks and avoid too small or too large blocks.

3. When using the Auto Digital Lost Foam Block Molding Machine china, it is strictly forbidden to put too much concrete into the hopper to avoid damage to the equipment and cause the equipment to fail to operate normally.

4. When it is necessary to shut down for maintenance or evacuate concrete, the power supply must be cut off immediately, and the operation must be performed after it has completely stopped working.

regular maintenance

1. Clean all parts of the Auto Digital Lost Foam Block Molding Machine china every week to prevent irreversible damage from accumulated dust and sundries.

2. Regularly check whether the lubricating oil is sufficient, and add lubricating oil in time if necessary.

3. Regularly check whether each part is loose, and tighten it if necessary.

4. If any abnormal situation is found, please stop the machine immediately and conduct an investigation. If the problem is serious, you can find the manufacturer's customer service personnel for maintenance.

Through the above introduction, we can understand the precautions for the use of Auto Digital Lost Foam Block Molding Machine china. Before use, it is necessary to make various preparations, operate the equipment correctly, and maintain the equipment. This can ensure the safe and stable operation of the equipment, prolong the service life of the equipment, and provide a strong guarantee for the construction of the project.